To update your Road Angel PURE firmware, please follow these instructions. This process typically takes between 15 and 45 minutes, though it can occasionally take up to an hour.
1. Download the Software
- Visit the Road Angel website at www.roadangelgroup.com and navigate to the 'Support Centre' section.
- Select 'Pure' in the Speed Awareness tab.
- Click the correct download link for your PC or Mac.
- If prompted, save the updater file to your 'Downloads' folder.
2. Installation Guide
For PC Users
- Open the downloaded 'Road Angel Updater' from your browser or file explorer.
- Select 'Allow' when asked if the program can make changes to your PC.
- Follow the on-screen prompts, clicking 'Next' and 'Install'.
- Click 'Finish' once the installation is complete.
For Mac Users
- Click the download arrow in the top right of your browser and open the Road Angel updater.
- Select 'Allow' to permit the program to make changes.
- Follow the on-screen instructions by clicking 'Continue' and 'Install'.
- Click 'Close' once the installation is finished.
3. Performing the Update
- Connect your Road Angel PURE to your computer using the provided USB cable.
- Launch the Road Angel Updater program from your desktop or start menu.
- Ensure your device is on and displays: "Connected to PC OK to unplug".
- The updater software should show a green tick and the message "Device Connected".
- Click the blue 'Update' button to begin.
Important: DO NOT UNPLUG the device during the update. Only disconnect once the PURE returns to the home screen or displays the "OK to unplug" message again.
If you encounter any issues during the update, you can contact the support team:
